LEDGlow Bluetooth Controlled Million Color Interior Kit

Tech Suppor t 856.768.5700 Ext.2 • TechSuppor t@LEDGlow.com 3 I NSTAL LAT I ON GU I DE 7. You can power this kit by running the power and ground wires directly to the battery, connecting it to the fuse panel using LEDGlow’s Expandable Circuit, or by using LEDGlow’s Cigarette Lighter Adapter, all of which are available at www.LEDGlow.com. • If you are running the power and ground wires to the battery and are going through the firewall or any other metal parts, you must protect the wires by using an existing grommet or by drilling a new hole in the firewall and adding a new grommet. Be sure to use 16 or 18 gauge automotive grade wiring and reinstall a fuse within 6 inches of the power source if you need to extend the wires. (Fuse not included if you extend the wires.) The red power wire connects to the positive (+) terminal, and the black ground wire connects to the negative (-) terminal of the battery. • If you are powering your interior kit using LEDGlow’s Expandable Circuit, be sure to power the kit from any 5-10 amp fuse. Remove the stock fuse from the fuse panel and insert into the empty slot of the expandable circuit, next to the included 4 amp fuse. Next, crimp the red power wire to the blue butt connector of the expandable circuit and insert the circuit into the empty fuse slot. Connect the black ground wire to an unpainted, bare metal ground source. • If you are powering your interior kit using LEDGlow’s Cigarette Lighter Adapter, place the red power wire into one of the open connectors and crimp the connector to secure the wire. Next, place the black negative wire into the remaining open connector and crimp the connector to secure the wire. Finally, insert the connector with the red wire to the positive wire on the adapter, and the black wire to the negative wire on the adapter. 8. If you removed any interior trim pieces for the installation, you can now reinstall those pieces and test the functionality of the kit once more. Optional Courtesy Light Feature Wiring Instructions: 1. The Courtesy Light feature will automatically change all installed lights to any of the 7 selectable colors when the doors are opened or when the dome light is activated. To utilize the optional courtesy lights feature, use a service repair manual to identify the wire used to power the dome light. Use a test light to locate the correct wire by opening and closing the vehicle’s door. Once the correct wire has been identified, disconnect the negative side of the vehicle’s battery and use a wire connector to attach the dome light wire to the white wire from the control box. When finished, reconnect the negative side of the vehicle’s battery. 2. Please note, some vehicles have a ground-side controlled system providing constant power to the dome light, which switches the ground on and off. This can be tested with a test light or multi-meter. There will be power on both sides of the bulb when the light is off. As soon as the light turns on, there will be power on one side and a ground source on the other. If this is the case in your vehicle, set the courtesy switch type set to GND on the settings page of the app. 3. If the vehicle’s dome light circuit is controlled by power and the ground never changes, set the courtesy switch type to 12V on the settings page of the app. 4. By default, the Courtesy Light Feature is turned off in the app. Make sure to turn it on in the app’s settings page after completing the wiring steps above.

RkJQdWJsaXNoZXIy MTIxODAy